Description: The plastic mold made of special plastic (polymer) is designed for the production of colored concrete products. The front surface of the mold simulates a cut of the board (fibers, knots, etc.).
The plastic mold is made in Russia by injection molding with stiffeners. The mold is ready to be filled and does not require additional tooling. The mold is used with all kinds of paving slabs.
Unused molds in the production process are recommended to be stored at a temperature of at least +6 degrees Celsius. It is forbidden to use molds in the production process after long-term storage at a negative temperature without preliminary exposure at a temperature of at least 15 degrees Celsius. It is forbidden to throw molds at all stages of the production process. Stacking in the poured form "one on one" is allowed.
In order to avoid the occurrence of "sticking" in the production, it is not recommended to use cement grade less than 500 D0 (satisfying GOST 10178-85), sand according to GOST 8736-93, crushed stone according to GOST 8267-93.
In case of "sticking" (in case of non-compliance with the relevant conditions of the technological regulations), it is prohibited to clean the molds from concrete using the dry method. It is possible to clean the molds from concrete after pre-soaking in a weak hydrochloric acid solution (3-4%) for at least 2 days, followed by cleaning with a soft natural brush under running water.
It is not recommended to transport filled molds during the concrete hardening process.
The color of the plastic mold depends on the presence of dye in the plastic and may vary. Number of pcs. per unit: 10 pcs. Quantity in the package: 10 pcs. Min purchase batch: 10 pcs. Method: Injection molding Always available