Plastic mold 12 bricks
$3.14
No tax
Dimensions: 500 x 500 x 50 mm
Qty. per m2: 4 pcs.
Quantity per package: 10 pcs.
Min purchase lot: 4 pcs.
Method:Injection molding
Product always in stock
Payment: cash, non-cash payment
Delivery: transport companies
Shipment: after making full payment
The front surface of the plastic mold conveys a pattern of 12 bricks (lomels) with a smooth and rough surface.
The mold is produced by injection molding with stiffeners made of special plastic in the Russian Federation in the city of Nizhny Novgorod and is intended for production using marble technology made of concrete.
It is not recommended to transport poured forms during the concrete hardening process. When using low-quality cement, it is recommended to periodically clean the form from adhering concrete. In the event of “sticking” (if the relevant conditions of the technological regulations are not observed), it is prohibited to clean the forms from concrete using a dry method.
The color of the plastic form depends on the presence of dye in the plastic and may vary.
We accept used rigid forms for exchange - for 10 old forms 1 new one. Before handing over the form, wash off the concrete mixture.
8 other products in the same category:
Dimensions: 500 x 500 x 50 mm
Qty. per m2: 4 pcs.
Quantity per package: 10 pcs.
Min purchase lot: 4 pcs.
Method:Injection molding
Product always in stock