Plastic mold California anti-slip
$0.94
No tax
Dimensions: 300 x 300 x 30 mm
Price does not include VAT
Qty. per m2: 11 pcs.
Quantity per package: 10 pcs.
Min purchase lot: 10 pcs.
Method: Injection molding
Always in stock
The front surface of the mold is covered with a notch in the form of a fine mesh to prevent slipping and conveys a “well” pattern (four and a half bricks).
The mold is produced by injection molding with stiffeners made of special plastic in the Russian Federation in the city of Nizhny Novgorod and is intended for the production of marble from concrete technology.
Transportation of poured forms during the concrete hardening process is not recommended. When using low-quality cement, it is recommended to periodically clean the form from adhering concrete. In the event of “sticking” (if the relevant conditions of the technological regulations are not observed), it is prohibited to clean the forms from concrete using a dry method.
The color of the plastic form depends on the presence of dye in the plastic and may vary.
We accept used rigid forms for exchange - for 10 old forms 1 new one. Before handing over the form, wash off the concrete mixture.
8 other products in the same category:
Dimensions: 300 x 300 x 30 mm
Price does not include VAT
Qty. per m2: 11 pcs.
Quantity per package: 10 pcs.
Min purchase lot: 10 pcs.
Method: Injection molding
Always in stock